Installation Guide

9
710443-100 Rev. A 8/18
6
ATTACHING SLIDING DOOR PANEL TO HORIZONTAL RAIL
1a. Carefully place Sliding Door Panel [32] onto Horizontal Rail [1] from inside of shower area and onto the Rollers [8].
NOTE: 2 people are required.
1b. Ensure bottom of Sliding Door Panel [32] ts into the open grove of Bottom Guide [6] and set into place.
1c. Remove threaded cover cap off Door Panel Guard [10] (clear plastic bushing end) and remove retaining screw inside with Philips head
screw driver and separate the 2 parts.
NOTE: Do not lose plastic spacer between these 2 parts! With supplied 2 clear plastic washers, place one washer over one end of Panel
Guard and one washer over the other end and place through hole of Sliding Door Panel [32] with thicker end pointing outside shower
area. Place Philips head screw back into place and tighten.
NOTE: If screw does not go back into threads, the 2 pieces are keyed and may be necessary to turn the parts 180 degrees. Door Panel
Guards can be adjusted so they are as close to the Horizontal Rail [1] as possible to prevent door from jumping off of Horizontal Rail.
1d. It may be necessary to place hex allen key into one of the holes of Guard to act as a handle or lever while tightening the screw in place.
Place threaded cover cap back onto Door Panel Guard. Repeat for other Guard.
1e. Attach Magnetic Seal [19] onto Door Handle side of Panel and snap into place.
1f. Attach Post [20] over Sliding Wall Post [21] and snap into place.
1g. Attach Side Gasket [16] to opposite side of Sliding Door Panel [32] keeping wider side toward outside of shower area.
1h & 1i. It may be necessary to trim a portion of Side Gasket [16] near the top to accommodate spacing for the Horizontal Rail [1].
[8]
[19]
[20]
[21]
[16]
[1]
[10]
1a 1b
1e
1c
1d
1f
1g
1h
1i
[8]
[6]
[32]
[19]
[10]
[16]
[20]
[21]
[10]