Installation Guide

8
710443-100 Rev. A 8/18
5
1a. Install Door Handle [2] onto sliding Door Panel [32] keeping clear plastic washers between the glass panel and handle.
1b. Tighten allen screws to secure Door Handle in place.
1c. Remove 10mm metal nut and 18mm plastic retainer from Roller [8] and carefully place threaded end into hole of outside facing sliding
Door Panel [32] keeping clear plastic washer between roller and glass panel. From inside shower side of panel, place 18mm plastic
retainer into threads of Roller and into hole of glass Panel, turn to tighten.
1d. Attach metal nut and tighten using 10mm socket and 18mm open end wrench for plastic retainer.
1e. Slide Bottom Door Gasket [18] onto bottom of sliding Door Panel [32] keeping the wider ap part to the inside of shower area.
1f. It may be necessary to cut or trim the Door Gasket material about 3/8" (10mm) off the edge of the sliding Door Panel.
ASSEMBLING ROLLERS AND SLIDING PANEL DOOR
[2]
[32]
[8]
[8]
[32]
[2]
[18]
[18] [18]
1a 1b
1c
1d
1e
1f
3/8"
10mm
3/8"
10mm
11/16"
18mm
3/8"
10mm