Installation Guide

710443-100 Rev. A 8/18

1a. Attach Limit Block [33] to Wall Connector [11a]. NOTE: Wall Connector [11a] has a threaded hole on one side to

accommodate the Limit Block.

1b. Attach Wall Connector with Limit Block to Connector Base Mount [12] on the Fixed Panel [31] side of shower and tighten 2

allen screws using supplied hex allen key.

1c. Slide second Wall Connector [11b] onto end of Horizontal Rail [1] (opposite 2 threaded holes) keeping chrome plated edge

facing outside shower and loosely tighten allen screws. Insert opposite end of Horizontal Rail [1] (end with 2 threaded holes

facing Fixed Panel) into Wall Connector [11a] and align threaded holes in Rail with holes in glass of Fixed Panel [31]. Then

slide opposite Wall Connector [11b] onto Connector Base Mount on other side of shower and loosely tighten allen screws of

Wall Connector [11b] to hold in place.

1d. Insert threaded end of Fixed Panel Fastener [9] through glass hole of Fixed Panel [31] from outside of shower keeping plastic

bushing in center of glass. Place other end of Fastener on opposite side of glass Panel and into the threaded end of

Fastener ensuring clear washers contact both sides of glass. Then turn Fixed Panel Fastener into one of the threaded holes

of the Horizontal Rail [1]. Repeat for second Fastener and tighten until both Fasteners securely hold onto glass Panel and

Horizontal Rail.

1e. Tighten Fixed Panel Fastener in place using hex allen key as a handle to tighten.

1f & 1g. Slide second Wall Connector [11b] onto Connector Base Mount [12] and tighten allen screws to securely hold in place.

ASSEMBLING THE HORIZONTAL

RAIL AND WALL CONNECTORS

[1]

[31]

[1]

[9]

[11b][11a]

[11a]

[11b]

[33]

1a 1b 1c