Installation Guide

710443-100 Rev. A 8/18

1a. Ensure Shim [7] is in groove on Bottom Guide [6] for Fixed Panel side.

1b. Carefully place Fixed Panel [31] fully into U Channel [28] and Fixed Wall Post [22].

NOTE: 2 people required.

1c. Check that Fixed Panel is fully and securely in place and panel is at far end (close to ush) on groove of Bottom Guide.

1d. Place level on top of Fixed Panel, if necessary level using Channel Shims [27] under Fixed Panel.

NOTE: Channel Shims come in 2 different thicknesses.

1e & 1f. Once panel is leveled and in place, insert Water Deector [17] on inside shower between Fixed Panel [31] and Fixed Wall Post [22].

1g. To install Sliding Wall Post [21] place on opposite side of shower entrance wall and mark approximately 1-5/8" (42mm) from threshold

edge of shower pan.

1h. Ensure Sliding Wall Post is plumb, then mark all 4 screw hole locations.

1i. Drill pilot hole at each marked location using a 1/4" (6mm) drill bit (if using Wall Anchors [24]).

1j. Insert Wall Anchors [24], place Wall Post into position and screw using M4x35 [23].

ASSEMBLING FIXED PANEL AND SLIDING WALL POST

NOTE: TWO PEOPLE REQUIRED

[28]

[22]

[21]

[31]

View from inside

[17]

[27]

[31]

[22]

[7]

[21]

1-5/8"

42mm