Installation Guide

10
710443-100 Rev. A 8/18
7
1a. Once all assembly is completed, it may be necessary to adjust the Sliding Door Panel [32] for proper operation. This can be
achieved by adjusting Rollers [8] attached to the Sliding Door Panel by loosening the metal nut on Roller.
1b. Use a 10mm socket to slightly loosen the metal nut on the Roller and an 18mm open end wrench to turn the plastic Retainer
which will provide an oblong effect when adjusting or turning causing the door to move up or down at that location.
Adjustments can be done to both Rollers to obtain proper door sliding operation and t.
ADJUSTING SLIDING DOOR PANEL
8
1a. Position the Aluminum Seal [29] at the entrance oor/Sliding Door Panel [32] side of the shower in line with the
Fixed Panel [31]. Apply and ll a bead of adhesive in the groove or underside of the Aluminum Seal and place
back at shower entrance keeping the sloping side of the Seal pointing inside the shower area.
1b. 2 Connector [30] ends are supplied to cover any gaps at the 2 ends of the Aluminum Seal which can be placed
on the left and right side to nish. Secure the Connectors at the Seal ends using adhesive.
INSTALLING THE ALUMINUM SEAL [29]
MIN
MAX
1a
1b
1a
1b
[30]
[29]
[29]
[30]
[8]
[8]
[8]
[8]