Installation Guide

8
INSTALLING HANDLE SET AND SIDE COVERS
• In this step, you’ll need following parts: [2], [12]
[10]
[24]
[9]
[9]
[12]
[12]
View from Inside
[2]
[1]
View from Inside
[10]
[2]
[1]
8c
8a
8a 8c
8b 8d
8a. Remove short end of threaded nut and washers from Handle Set [12]. This end of the Handle Set should
be installed nearest the door hinges. Ensure the clear washers are installed inside and outside of Door
Panel [9] as illustrated. Lightly snug threaded nut.
8b. Remove longer end of threaded nut and washers from Handle Set [12] and install into hole on opposite
end of Door Panel [9] while keeping the clear washers between the inside and outside of the glass. Tightly
snug the threaded nut to secure Handle Set [12] to Door Panel [9].
8c. Slide Side Cover [2] over Wall Post [1] as illustrated.
8d. Fully insert Side Cover [2] into Wall Post [1] and push into place to cover and trim Wall Post [1].