Installation Sheet

“C” Pull Handle / Towel Bar Combination

Installation Instructions

There are eleven hardware components for the Combination Door Pull and Towel Bar mounting:

One pull; one towel bar; two end caps with threaded studs; one stud head screw; and six clear gaskets

to act as a buffer between the hardware and the glass.

Take the stud head screw and both end caps

with a stud protruding and sleeve a clear gasket on

each of the screws.

The towel bar will be mounted first. Take the

stud head screw with the washer and gasket attached.

From the inside of the enclosure, push the threaded

portion through the top hole in the glass on the strike

side of the door. Place a clear gasket over the stud

head screw on the outside of the glass door. Now thread

the stud screw into the towel bar and tighten. On the

other end of the towel bar (on the hinge side), push one

of the end caps with the stud protruding through the

hole. Now place a clear gasket over the threaded stud

on the outside of the glass door. Thread the end cap into

the towel bar and tighten by hand. Tighten the stud head

with a screwdriver and the end cap by hand.

The towel bar is now complete. Now it is time to mount the pull portion. From the outside

of the enclosure, push the end cap with the stud protruding through the bottom hole of the door.

First place a clear gasket over the threaded stud on the inside of the glass door. Now thread the

stud into the small threaded opening of the pull. Do not tighten this end of the pull down at this

time. Place the end of the pull with the large hole and the set screw over the stud head.

Now tighten the end cap by hand as tight as possible. Use the Allen wrench provided to tighten the

set screw on the pull to the stud head screw.

QCI5239 Rev 0 Page 12 Certified 06/20/2016