Installation Sheet

13 Grab the remaining vinyl pieces from Step #9.
Cut two (2) pieces of the vertical vinyl [I] 1” longer
than the vertical opening. Remove the tape from the
glass. Starting on the exterior, slide one end of the
vertical vinyl up into the header and press into
the wall jamb about 6” down.
Apply light pressure against the interior of the glass
panel to hold vinyl in place and install vinyl on the
interior in a similar fashion. Press the vinyl into the
wall jamb alternating between the interior and exterior.
Caution: Do not to stretch the vinyl when pressing into place
and keep the glass pushed against the snap-in fillers.
VERTICAL
OPENING
GLAZING
VINYL
WALL
JAMB
GLASS
PANEL
OVERHEAD
VIEW:
14 Remove the small pieces of vinyl installed in Step #9.
Cut four (4) pieces of the horizontal vinyl [J]
1/2” longer than the horizontal opening. Cut the end
of each piece of vinyl where it meets the wall jamb
with a back mitre (see illustration). This will allow it
to sit tight against the face of the vertical vinyl. Cut
the other end of each vinyl piece square so it will sit
tight against the side of the strike snap-in filler
Starting at the top on the exterior, place the vinyl against
the glass (open side of the crescent shape against the glass)
and press into the header at both corners. Continue
pressing vinyl into the header from both ends working
toward the middle. Be sure that the glass is centered in the
header or the vinyl might fall out until the interior vinyl
is installed
Repeat for the the top interior vinyl and then both bottom
vinyl pieces.
HORIZONTAL
OPENING
HEADER
CURB
HORIZONTAL
VINYL
GLASS
PANEL
VINYL
REMOVE
HEADER
HEADER
SNAP-IN
FILLER
CURB
15 Measure the exposed glass edge of the stationary
panel (between top & bottom snap-in fillers).
Cut the polycarbonate strike jamb [P] to that measurement.
Carefully press the strike jamb over the edge of the
stationary panel.
Pull the bottom glazing vinyl back from the snap-in filler
so the strike jamb will sit on top of the snap-in filler.
Re-install the vinyl after the strike jamb is in place.
TIP: For the best results, cut the strike jamb on the end
that would be at the bottom.
HEADER
HEADER
SNAP-IN
FILLER
CURB
CURB
SNAP-IN
FILLER
OPENING FOR
POLYCARBONATE
STRIKE JAMB
QCI5239 Rev 0 Page 8 Certified 06/20/2016