Installation Sheet

7 Slide the header over the wall jambs.
Using the two holes on the interior face of the
header as a guide, drill a 1/8” hole into each
wall jamb. Attach the header to the wall jambs
using two #8 x 1/4“ Truss Head screws [H].
TIP: Slide the glass panel out of the wall jamb
before drilling to prevent damaging the panel.
Measure the door panel width. (see illustration)
Measure the horizontal door opening (between the
wall jamb and the exposed glass edge) at the top,
middle and bottom of the opening.
The minimum horizontal dimension of the door
opening is the door panel width plus 3/8”.
The maximum horizontal dimension of the door
opening is the door panel width plus 5/8”.
#8 X 1/4”
SCREW
DOOR
OPENING
DOOR
OPENING
#8 X 1/4”
SCREW
Hinge
Jamb
Vinyl
Sleeve
Hinge
Rail
Vinyl
Glass
Door Panel Width
9 Once the panel is set in place, cut four
small pieces of the horizontal [J] (crescent shaped)
vinyl about 3” and install them into the header
and curb (open side of the crescent shape against
the glass). This will help hold the panel in place
while installing the door panel.
Set the rest of the vinyl to the side for later
installation.
8 Inspect the strips of black glazing vinyl and note
the two different profiles. The flat shaped vinyl [I] is
installed vertically and the crescent shaped vinyl [J] is
installed horizontally. There should be a minimum of
two (2) individual vertical and four (4) individual
horizontal pieces of vinyl about a 1/2” wide each.
(May need to peel apart from a wider strip).
These vinyls are designed to fit tightly between the glass
and metal frame. TIP: Wet the glass and vinyl with water
or glass cleaner immediately before installing vinyl and
use a small block of wood to press the vinyl into place.
NOTE: Different glass sizes require different vinyl. Refer to
the chart for clarification if installation is extremely difficult.
GROOVE
GROOVE
HEADER
CURB
HORIZONTAL
VINYL
GLASS
PANEL
HORIZONTAL
VINYL
QCI5239 Rev 0 Page 6 Certified 06/20/2016