Installation Guide

QCI5297 REV. 0.1 Page 6 Cered 10/1/17

Lightly mark a continuous unit centerline on the

threshold.

Next, mark a continuous unit centerline up each wall,

starting where the threshold centerline meets the wall.

Use a level to ensure the wall centerline is plumb and

straight. The wall centerlines should be a minimum of

the unit height from the threshold.

Note: It is extremely important the unit cen-

terline be continuous and straight to ensure

proper installation.

On the wall selected for installation of the door, check the fit of SC982 Hinge Jamb [2] where the

threshold and wall meet. In many cases the corner will need to be contoured to fit a radius.

Contour the corner as required to ensure proper contact with the wall and threshold.

Proper fit in this area allows the door to be installed on a fiberglass enclosure or walls

with no blocking. Failure to radius the corner for proper fit may cause the door to fall

causing property damage and bodily harm.

Note: It is imperative that SC982 rest on the threshold. Out-of-Level conditions may dictate the

door and SC983 jamb assembly be raised such that SC983 does not contact the threshold. This

installation is permissible.

Centerline (CL) is a term used to describe the center or mid-point of the unit. The most common unit

centerline position is the middle of the threshold. CL is marked in when visible in images.

NO!

YES!