Installation Guide
QCI5297 REV. 0.1 Page 20 Cered 10/1/17
To prevent the door from sagging after final
gap adjustment the hinge maybe shimmed
to prevent movement.
Remove one hinge back plate at a time and fill
gaps (marked in the figure to the left) surrounding
hinge with shims supplied in parts pack. Make
sure to shim both hinges and use combination of
shim thicknesses to fill entire gap.
30
Open the door. Place the Panel Glass [7] into the u-channel, making
sure it sits on the setting blocks. Check the panel for level and plumb.
If required, remove the panel and adjust the total size of the setting blocks to
adjust the panel for height and plumb.
The setting blocks maybe stacked as required.
28
Pull the panel to the
edge of the Thresh-
old U-Channel [4].
Carefully close the door.
Check for a consistent
3/16” gap between the
door and panel. Adjust the
panel’s position as neces-
sary to achieve the proper
gap.
29
Panel Glass [7]
Threshold U-Channel [4]
Door Glass [1]
3/16” GAP