Installation Sheet
QCI5301 Rev 1 Page 26 Cered 6/5/2017
33 Push the inner panel to 1
wall.
Slide 1 piece of Anti-Jump Vinyl
behind the inner panel.
Near the other wall, begin snap-
ping the Anti-Jump Vinyl onto
the Header. For best results,
leave 1/4” between the end of the
header and the Anti-Jump Vi-
nyl.
Continue snapping the vinyl onto
the header towards the center of
34 Repeat for the other Anti-Jump Vinyl piece.
Push the inner panel to the other wall.
Slide the Anti-Jump Vinyl behind the inner panel, meeting the already installed piece in the
middle.
Beginning in the middle of the unit, snap the Anti-Jump Vinyl onto the header, ending with a gap
SNAP ANTI-JUMP VINYL ONTO
LIP OF HEADER AS SHOWN