Installation Guide

710286-100 Rev. 2 03/2020

FITTING FRAME ASSEMBLY INTO OPENING

2 PEOPLE REQUIRED

2 3

Installation Range

57-1/2" – 58-1/4"

(1460 – 1480mm)

MARKED HOLES

Mark holes

DO NOT install screws

Use 1/4" drill bit

for anchor holes

DRILL MARKED

LOCATIONS

INSTALL ANCHOR

IF NEEDED

Place completed frame onto the tub marked edge

at the edge of the at surface of the deck. Push

wall posts against wall and position the posts with a

level and mark the mounting holes on the wall. (Ref. 1)

Remove the frame; drill 1/8" holes at marked locations.

(Ref. 2)

Use the anchors if NOT securing to studs

(use 1/4" drill bit). (Ref. 3)

Remove frame and proceed to STEP 3.

FITTING FIXED GLASS PANEL INTO FRAME ASSEMBLY

*if not previously installed onto Fixed Door Post!

View from inside

RIGHT-HAND FIXED PANEL SHOWN. SEE PAGE 8 FOR

LEFT-HAND INSTALLATION.

1. Place Retaining Blocks (12) on fixed door panel at top and bottom (see Fig. A)

and use them as guides to install the top and bottom Fixed Door Water

Deflectors (21). Once the Water Deflectors are in place, remove the

Retaining Blocks for later installation.

2. Slide Fixed Glass Panel (14) in place, engaging Top and

Bottom Horizontal Rails and Door Post

4. Install Fixed Door Water Deflector (24) by pressing into place. Wet with

water to aid inserting deflector between glass door and door post. Deflector

may need to be trimmed if it extends beyond the top or bottom rail.

3. Install top & bottom Retaining Blocks with screws (11) to hold Fixed Door

Panel in place.

NOTE: Hand tighten screws. Do not over tighten!

FIG. A

Fix e d Pa n e l

VIEW FROM INSIDE