Installation Guide

710286-100 Rev. A
5
3
2
FITTING FRAME ASSEMBLY INTO OPENING
2 PEOPLE REQUIRED
1
2
3
1
2 3
A
57-1/2" x 58-1/4"
(1460 x 1480mm)
ANCHOR INSTALL
Mark holes
DO NOT install screws
Use 1/4" drill bit
for anchor holes
DRILL FOR ANCHOR
IF NEEDED
INSTALL ANCHOR
IF NEEDED
Place completed frame onto the tube located edge
at the edge of the at surface of the deck. Push
wall posts against wall and position the posts with
a level and mark the mounting holes on the wall.
Remove the frame; drill 1/8” holes at marked
locations.
Use the anchors if NOT securing to studs (use 1/4”
drill bit).
Remove frame and proceed to STEP 3.
A
FITTING FIXED GLASS PANEL INTO FRAME ASSEMBLY
VIEW FROM INSIDE
View from inside
RIGHT-HAND FIXED PANEL SHOWN. SEE PAGE 8 FOR
LEFT-HAND VERSION.
1. Place Retaining Blocks (12) on glass at top and bottom (see Fig. A) and
use them as guides to install the top and bottom Water Deflectors (15).
Once the Water Deflectors are in place, remove the Retaining Blocks for later
installation.
12
3
12
10
12
19
10
1
2
4
2. Slide Fixed Glass Panel (14) in place, engaging Top and Bottom Rails and
Door Posts.
3. Install top & bottom Retaining Blocks with screws (11) to hold Fixed Glass
Panel in place.
4. Install Water Deflector (19) by pressing into place.
(NOTE: The Water Deflector may need to be trimmed if it extends beyond
the Top (17) or Bottom (9) Horizontal Rails.)
11
FIG. A
19
Fix e d Pa n e l