Installation Guide

- 1 -
SPOUT BASE
4
Fig. A.
Fig. B.
1
2
3
6
5
5B
7
2
1
4
3
4B
5
5
Product names listed herein are trademarks of AS America, Inc.
© AS America, Inc. 2016
Congratulations on purchasing your American Standard faucet
with Speed Connect drain, a feature found only on American
Standard faucets.
Speed Connect
®
Drain*
• Fewer parts, installs in less time
• Never needs adjustment
• Guaranteed to seal properly the rst time, every time.
*Your new American Standard faucet is designed to work only with the Speed Connect drain.
To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.
RECOMMENDED TOOLS
1
M965735 Rev. 1.1 (7/16)
INSTALL SPOUT
TOWNSEND
®
DUAL CONTROL WIDESPREAD
LAVATORY FAUCET
WITH SPEED CONNECT
®
DRAIN
INSTALLATION
INSTRUCTIONS
7353.801
7353.841
Flat Head Screwdriver
Adjustable Wrench Tubing CutterSlip Jaw Pliers
Certied to comply with ANSI A112.18.1M
CAUTION
Turn off hot and cold water
supplies before begining.
1A
Fig. B.
• Place RUBBER RING (1) into DECK
ADAPTER (2).
• Install LOCKNUT (3), RUBBER WASHER (4)
and FRICTION WASHER (4B) onto VALVE
BODY (5).
From under side of mounting surface, install
VALVE BODY (5) through valve mounting
hole. Threads of VALVE BODY (5) should
extent at least 5/16 of a inch above mounting
surface top. Fig. A. Thread DECK ADAPTER
(2) onto VALVE BODY (5) until snug against
internal stop.
If necessary, adjust LOCKNUT (3). Tighten
LOCKNUT (3) with WRENCH (6) supplied.
INSTALL VALVE BODIES
Fig. A.
• Insert SHANK (1) CABLE CONNECTOR (2) and HOSE (3) through center hole,
making sure SEAL WASHER (4) is properly seated in spout base.
• Assemble RUBBER WASHER (5), FRICTION WASHER (5B) LOCKNUT (6)
and thread LOCKNUT (6) onto SHANK (7) from underside of sink or
mounting surface.
• Align and center SPOUT (1). Tighten LOCKNUT (6).
Hex Wrench