Installation Guide

770035-100 Rev. A
- 3 -
MARBLE TOP 9212124 WITH ORBIT 0630 UNDERCOUNTER SINK...
Two people recommended for this installation
NOTE: Marble top comes pre-cut for the Orbit Undercounter Sink and 8"
faucet spread. Also it is strongly recommended that the marble top be sealed after
installation and prior to use.
Mount the drain assembly (not included) on the sink. Be certain to apply a bead of
sealing putty on the underside of the drain (Part "A") in order to ensure a watertight seal
between the sink and drain. Remove excess putty after installing the drain on the sink.
Turn the marble top upside down and place it on a clean, scratch
resistant surface. Apply a bead of silicone adhesive to the rim of
the sink. Center the sink over the cutout and (secure it to the top
using the mounting kit provided).
NOTE:
Use the 4 brackets and screws supplied with the sink
mounting kit to secure the sink to the underside of
the marble top.
Turn the top right-side up and install the faucet per the manufacturer’s
instructions.
Apply a bead of silicone adhesive to the rim of the vanity. Place the marble top
centered left to right on the vanity and with the back edge of the top even with the
rear of the vanity. Clean up any excess silicone.
Connect the trap to the drain assembly hand tight to check alignment. It may be
necessary to cut off part of the tailpiece (area "A") or part horizontal leg of the trap
(area "B").
Connect hot and cold supply lines to the shut off valves. Tighten trap joints for
watertight assembly.
TROPIC GRANDE PEDESTAL SINK 0404.004 or 0404.008 INSTALLATION onto VANITY…
Two people recommended for this installation
Mount the drain assembly (not included) on the sink. Be certain to apply
a bead of sealing putty on the underside of the drain (Part "A") in order to ensure
a watertight seal between the sink and drain. Remove excess putty after installing
the drain on the sink.
Apply a bead of silicone adhesive to the rim of the vanity. Place the top centered left to
right on the vanity and with the back edge of the top even with the rear of the vanity. Apply
a bead of silicone along the top back edge of the vanity top and the wall. Clean up any excess silicone.
Connect the trap to the drain assembly hand tight to check alignment. It may be necessary
to cut off part of the tailpiece (area "B") or part horizontal leg of the trap (area "C").
Connect hot and cold supply lines to the shut off valves. Tighten trap joints for watertight assembly.
A
B
A
ORBIT UNDERMOUNT SINK
(IT IS NOT AN EXACT
REPRESENTATION)
MOUNTING BRACKET
(ILLUSTRATION MAY NOT
REFLECT EXACT LOCATION)
MARBLE TOP
OVERFLOW TOWARDS
FRONT OF MARBLE TOP
B
C
A