Installation Guide

2
7301793-100 Rev. F
S
A
N
I
G
U
A
R
D
NOTE: For more detailed information, see the
installation instructions supplied with the
IC FAUCET. # M965119
3
2
1
36-1/2"
(927mm)
18"
(457mm)
SQ-0-4437 FLOOR
MOUNTED SINK
SUPPORT
1-5/8"
(41mm)
FINISHED WALL
MOUNTING
STUDS
8" (203mm)
FINISHED
FLOOR
INSTALL FAUCETROUGH-IN SUPPLIES AND WASTE OUTLET
INSTALL GRID DRAIN AND OFFSET TAILPIECE
1. Insert WIRES (1), FLEX HOSE (2) and SPOUT SHANK (3)
through center hole of mounting surface.
2. Assemble "C" WASHER (4), STAR WASHER (5) and LOCKNUT
(6) onto threads of SPOUT SHANK (3) from underside of
mounting surface.
3. Align FAUCET and tighten LOCKNUT (6).
1. Apply plumber’s putty to the underside of flange. Install GRID DRAIN into drain outlet.
2. From the underside of SINK install RUBBER GASKET (flat side up) and FRICTION
GASKET onto GRID DRAIN threads. Apply sealent to threads of GRID DRAIN.
3. Apply sealent to threads of OFFSET TAILPIECE and thread into DRAIN ELL.
4. Thread DRAIN ELL onto GRID DRAIN, tighten and align as shown.
1. Rough-in 3/8" supplies and waste outlet connections.
1
2
3
4
5
6
6
5
4
3
3/8" (10mm)
SUPPLIES
4"
(102mm)
*CHECK LOCAL CODES
RUBBER
GASKET
FRICTION
GASKET
APPLY
SEALANT
APPLY SEALANT
TO THREADS
DRAIN ELL
OFFSET TAILPIECE
DRAIN ELL
GRID DRAIN
2
3
4
NOTE: For ease of installation and accessibility, it is
recommended that straight stops with flex
supply tubes be used. As an alternative, if rigid
supply risers are used, it is suggested to use
angle stops in place of the straight stops.
*1-1/4" (32mm)
OR 1-1/2" (38mm)
WASTE OUTLET
PLUMBER’S
PUTTY
GRID DRAIN
1