Installation Guide

770278-100 Rev. 1 05/2020

Install the outer vanity legs onto the pre-drilled holes of the vanity using x4, supplied M6 pan head screws as noted in the illustration.

Install the inner set of vanity legs between the opposite side of vanity and one side of the bridge as shown in illustration using the

x4 supplied M6 pan head screws. Attach other leg assembly over second vanity and opposite side of bridge in the same manor.

Note: 24" double vanities do not require an inner set of vanity legs

Note: With all optional legs connected to the vanities and optional bridge, it will be necessary to screw the optional bridge to the

vanities in order to secure all 3 pieces together as one piece before mounting onto the cleats on the wall. Follow "Connecting

Optional Bridge To Vanities" then continue with vanity installation from Step 6.

Installing Optional Legs on Dual Vanity With Bridge

From inside the vanity there are 4 pre-drill locations,

screw into each pre-drill location from the vanity into

the bridge using supplied #6 1-1/4" screws connecting

bridge to vanity. If a second vanity is being used,

install 4 #6 1-1/4" screws into the 4 pre-drilled

locations in the second vanity into the bridge.

Connecting Optional Bridge to Vanities

a) Apply a bead of adhesive around all

4 sides of the top edge of the vanity

where the Wooden Counter Top will sit.

b) Place the counter top evenly on top

of the vanity and clean any adhesive

that may run out.

c) Attach optional wooden counter top with

4 #6 x 1-1/4" screws supplied. With the

drawers removed from the vanity, locate

4 pilot holes in top of unit. Install screws

through the 4 pilot holes from the

underside up into the bottom of the

countertop.

Installing Optional Wooden Counter Top

PRE-DRILLED SCREW HOLE

OUTER VANITY LEGS

NOTE DIRECTION OF FLANGE ON INNER VANITY LEGS

PRE-DRILLED

SCREW HOLES