Installation Guide

3
Place cleat on line, check level and screw in place using
3 #10 x 2" wood screws.
Installing Vanity Cleat
5
770278-100 Rev. 1 05/2020
Place vanity onto cleat on the wall and check for
level in two directions, front to back and side to
side. Shim as needed to ensure vanity is level.
Installing Vanity Onto Cleat
6
Using 3 #10 x 2" wood screws, screw through the back
wall of the vanity rmly securing it to the wall. Repeat
procedure if using Optional Bridge or second vanity.
Note: If installing Optional Wooden Counter Top,
proceed to Step 13 Installing Optional Wooden
Counter Top.
Note: If installing Optional Bridge or a second vanity to
the bridge, see Step 11 Connecting Optional Bridge
to Vanities.
Attaching Vanity To Wall
7
Following manufacturer’s instructions, install faucet and
drain assembly (not included). Apply a bead of sealing
putty on the underside of the drain (see detail A) in order
to ensure a watertight seal between the sink and the
drain. Remove excess putty after installing drain on sink.
Faucet And Drain Installation
8
A
Line
Cleat
SCREW LOCATIONS
FRONT VIEW OF VANITY