INSTALLATION INSTRUCTIONS AquaWash® 2.0 SpaLet® Seat Model 8019A60GPC Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.) Also be sure your installation conforms to local codes. NOTE: Pictures may not exactly depict toilet seat and components.
1 SpaLet® Seat 2 Fixing Components Bolt (2) Insert (2) (Apply to Top Mount) Base Plate (1) CONNECTION HOSE WITH FILTER 5 USER’S MANUAL INSTALLATION INSTRUCTIONS GASKET AquaWash® 2.0 SpaLet® Seat Model 8019A60GPC Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure this product is installed properly, please read these instructions carefully before you begin. (Certain installations may require professional help.
INSTALLATION Please read the instructions carefully before installing and using. WARNING 1 The product requires a flexible supply hose. The water shutoff valve should be near the installed product for ease of installation. Do not use in hot water line. Temperature above 104°F / 40°C will damage the product and void your warranty. 2A Remove existing toilet seat. Press the inserts into the toilet bowl holes.
5 Install T-shaped adapter to the fill valve and supply hose as shown. Connect the included connection hose with filter on to the T-shaped adapter and the SpaLet® seat inlet. 6 Make sure the control knob on the SpaLet seat is at the 90˚ off position. Turn the water shutoff valve back on. WARNING Make sure the filter and seal on the connection hose are installed along with the hose. OFF POSITION DO NOT OVERTIGHTEN THE THREADED CONNECTIONS.
KNOB OPERATION 1. When the power cord is plugged into the AC wall socket, the SpaLet® is automatically powered ON and the KNOB light and Night light are constantly ON. 2. When the KNOB is turned to the Front or Back washing function, the KNOB’s light will start to glow ON & OFF indicating one of the wands are extending. 3. When the KNOB is in the OFF or 90 degree position, the KNOB’s light is ON.
WATER AND SEAT TEMPERATURE SETTINGS For Water Temperature description, follow below Press the icon illustrating the “Water ” temperature button and the LED light for it will turn ON indicating Low Temp or about 95ºF / 35ºC. Press the button again and the LED light will appear brighter indicating a higher temperature, about 100ºF / 38ºC. Press a 3rd time and the LED will go OFF indicating heater is off.
CLEANING AND MAINTENANCE 1 2 DO NOT USE AGGRESSIVE CHEMICALS: for example: hydrogen chloride, paint thinner, benzene, abrasive cloth or paper, polishing agent, fragrance, insecticide, etc. Insecticide You will need to clean the wands when they get build up of residue and calcium. You can pull the wands out with your finger and then with a soft bristle toothbrush, brush the nozzle head.
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION Water is too low during WASH/BIDET 1. Low water pressure of the unit 2. Low water pressure of water supply During WASH/BIDET, turn the knob to a higher setting When water supply pressure is lower than 0.07 MPa (10 psi) No water comes out during WASH/BIDET 1. 2. 3. 4. 5.
