Use and Care Manual

4 - EN
BE SURE TO FOLLOW THE IMPORTANT SAFEGUARDS
When the device is used by children, the elderly
or persons with mobility impairments you must
ensure that they won’t fall off. There is a risk of
injury and damages to the device.
The on-site electrical installation and connecting
the device to the power mains must only be
performed by authorized and qualied
electricians, who are well versed in the locally
applicable regulations and supplemental
requirements and know the requirements of the
local utility providers extensively.
Improper installation and maintenance work or
repairs can create substantial hazards to the
user, for which we cannot be held liable.
Do not apply impact to the
clip ring or pull it when
cleaning the SpaLet seat, as
the clip ring may break and
the water supply hose may
come off, resulting in ood-
ing.
Turn off the power at the power breaker or
disconnect the power plug from the outlet when
cleaning. Failure to do so may cause electric
shock. (Ensure the power is turned on when
using the nozzle cleaning function.)
This product is not intended to be used by young
children, persons with physical and/or mental
disabilities, or persons lacking experiences and
knowledge without the supervisions and instruc-
tions of the person responsible for the safety and
understands possible hazards.
Children shall not play with the product.
Do not bend or crush the water supply hose,
as this may result in water leakage
and ooding.
Note the following when using the strainer. If for-
eign materials are attached to the O-ring, it may
cause ooding due to water leakage.
– Close the water shut-off valve when
removing the strainer.
– When installing the strainer, tighten it
fully so there is no gap.
– Check that the O-ring is free from
foreign materials when attaching it.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This devise may not cause harmful Interfer-
ence, and
(2) This devise must accept any interference
received, including interference that may
cause undesired operation.
Warning: Changes or modications to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer-
ence in a residential installation. This equip-
ment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation. If
this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
SAVE THESE INSTRUCTIONS