Use and Care Manual

38 - EN
Installing the Nozzle Tips
* If the nozzle wand retracts, follow the steps
n
2
and
n
3
in the section, "Removing the Nozzle Tips," again to
extend the nozzle.
n
1
Align the Detach mark on the right side of
the nozzle tip with the Center mark on the
nozzle wand, and then insert the nozzle
tip fully and turn it clockwise until it can
no longer be turned.
* Hold the nozzle at its base with your hand when
installing the nozzle tip.
②
①
Turn
clockwise
O-ring
Center mark
Center mark
Detach mark
Insert
[CAUTION]

● There are two nozzles; one for back cleansing and
the other for front cleansing. Be sure to install the
nozzle tips to their nozzle wands.

● When installing the nozzle tip, make sure that the
hole on the nozzle tip is positioned at the top.

● Be careful not to damage the O-ring.
n
2
Check the joint.
Joint
Center mark on
nozzle wand
Center mark on
nozzle tip
[CAUTION]

● After the installation, make sure that the Center
mark on the nozzle tip is aligned with the Center
mark on the nozzle wand.
* If the two Center marks are not aligned, a malfunction
may occur and the angle of the discharged water may
deviate from the proper position.
n
3
Press the [Stop] button to retract the
nozzle.
[Stop]