Use and Care Manual

9 - EN
Seat sensor switch
(Built into the seat unit)
Operate the Spray
n
1 Roll up your sleeve and set
your arm on the SpaLet
®
seat.
* The SpaLet seat is equipped with a seat sensor
that detects the presence of someone sitting on
the SpaLet seat.
The Spray and dryer will not function if the sensor
is not triggered.
* Allow the spray to operate for approximately 30
seconds to bleed air in the water line during initial
use.
n
2 Press the [Cleansing] button.
* At this time, water will discharge from around the
nozzle as a preliminary operation.
n
3 Place a hand above the noz-
zle tip to block the sprayed
water.
n
4 Press the [Stop] button to
stop the SpaLet.
Preparation and Checks Before Use
STEP
3