Installation Instructions

-6 - EN-
Remove the parts from the box and make sure all the parts in the parts list (below) are
present. Inspect the parts carefully to make sure they are in good condition.
If any part is damaged or missing, do not install this product. Contact the nearest customer
service representative for the part(s) you need.
The following parts are included:
•
SpaLet
®
seat unit (with heated seat, seat lid and power cord)
•
Mounting plate
•
Manual set
•
Mounting bolts, washers, and bushings (2 pieces each)
•
Junction fitting (with a packing)
•
SpaLet seat unit water supply hose (with 2 clips)
•
Remote control
•
Holder
•
Batteries
•
Wood screw
•
Plastic anchors
3. Installing This Product
Installation Requirements
Before installing this product, ensure that each of the following installation
requirements are met.
Contents
SpaLet seat unit
Packing
2 mm (0.08")
thick
Junction fitting
Manual set
Clip
Clip
water supply
SpaLet
seat unit
hose
(37.40'' (950 mm) long)
Mounting bolt
Bushing
Mounting plate
(This plate attaches to the SpaLet seat unit.)
Mounting
bracket
Washer
Batteries (2) Wood screws
Plastic anchors
Holder
Remote control unit
*Remote control unit and holder are
packed in the box.
For remote control unit