Installation Instructions

-18 - EN-
(1) Turn the water shut-off valve clockwise to close it.
As the water shut-off valve is pre-adjusted, keep track
of the turns so that you can return to the original
position.
(2) Remove the filter located on the left side of the SpaLet
®
seat unit.
Place a wash bowl or similar item underneath the Filter.
(3) Rinse the filter.
(4) Firmly tighten the filter.
(5) Open the water shut-off valve by turning it back to its
original position.
(1) Close the water shut-off valve to shut-off the water
supply.
* If the open/close knob is difcult to turn, grasp it with a dry cloth
and turn.
(2) Move the flush lever to drain water from the toilet tank.
(3) Drain the water from the water supply side.

Place a basin or similar beneath the strainer.

Remove the strainer, rinse away dirt that has attached to the
strainer and O-ring, and then completely remove the part.

Insert the power plug into an outlet.

Press and hold both the [Massage] and [Nozzle Position ]
buttons for at least 2 seconds.
* Remaining water in the toilet body will drain over a 15-second
period.

Disconnect the power plug from the outlet.

After the water has been drained, securely reattach the strainer.
(4) Check for leaks from the water shut-off valve.
Water
Valve
Water
Valve
Turn
clockwise
Turn
counterclockwise
mark of the mounting plate
Convex part of the
back of the seat unit
Filter
Filter
Lock Lever
Turn
counterclockwise
Strainer
Water supply
socket
Flat-blade
screwdriver
3. If the flushing begins to weaken, or if the nozzle spray
seems to be getting weaker, clean the filters.
4. If freezing weather is anticipated, drain the water.
Water
Valve
Water
Valve
Turn
clockwise
Turn
counterclockwise
mark of the mounting plate
Convex part of the
back of the seat unit
Filter
Filter
Lock Lever
[Massage]+[NozzlePosition ]
Turn
clockwise
Tighten until the end surface
of the strainer is flush with
the socket end surface.