Installation Instructions

-16 - EN-
[Note 7-1]
Ensure to install the batteries in the correct
direction(notethenegativeandpositive).
Do not mix old and new batteries.
Use the supplied batteries.
[Note 7-2]
Ensurethatthereisenoughspaceabovetheremote
control installation position to allow easy removal
andmountoftheremotecontrol(seethegure
below).
Remote control space
80 mm
270 mm
When multiple SpaLet
®
seat units are installed:
When multiple SpaLet seats are installed, a SpaLet seat in other booth may also respond to the signal and
cause malfunction. To prevent this, you can change the signal using the remote control unit you purchased.
Change both the emitting signal (remote control unit) and receiving signal (SpaLet seat).
1. Changingemittingsignal(remote
controlunit)
(1) Remove the batteries from the remote control
unit.
(2) Refer to the signal table on the right, hold
down the desired button, insert the batteries
and wait for six seconds (twenty seconds for
Cleansing and Bidet button) with the button
held down.
(3) When the emitting signal has been changed,
the battery mark on the lower right of the re-
mote control ashes.
(The number of ashes differs depending on
the signal that has been changed.)
2. Changingreceivingsignal
(SpaLetseat)
(1) Remove the power plug of the SpaLet seat for
which the signal is to be changed.
(2) Insert the power plug again, and then press
the [Stop] button at least 10 times within 10
seconds after insertion.
NOTE: Do not turn on and off the indoor (equip-
ment) breaker to perform the above operation.
* If power is turned on simultaneously for multiple
SpaLet seats, the receiving signal of other bidets
may be changed.
* Some signals cannot be set on some products.
Signal
Number
Operation Button Battery Mark
No. of Flashes
Signal 1 Water Temp Once
Signal 2 Seat Temp Twice
Signal 3 Power save Three times
Signal 0 Nozzle Cleaning Four times
Signal 4 Spray Strength - Five times
Signal 5 Spray Strength + Six times
Signal 6 Cleansing Seven times
Signal 7 Bidet Eight times
*Signal0isthedefaultsetting.