Installation Instructions

-15 - EN-
6. Positioning and Mounting the Remote Control
● Remote control installation position
Install the remote control to a position where the
user can reach and operate it.
Install the remote control in the area shown as “Suggested
installation area” in the gure below, and ensure to install the
remote control on a position where it can be operated easily
while the user is seated on the SpaLet
®
seat.
900 mm (35-7/16")
600 mm (23-5/8")
800 mm (31-1/2")
1200 mm (47-1/4")
Suggested installation area
●
Sit on the SpaLet seat and ensure the installation
position.
[See Note 7-1]
Temporarilyinstalltheremotecontroltothetargetposition,and
sit on the SpaLet seat unit and press the [Stop] button
(ensure
toperformatestoperationafterinstallation).
Then, stand in front of the toilet bowl
and push the [Stop] button to ensure
that a beep sound is generated from
the SpaLet seat unit.
• Do not push the [Cleansing] or [Bidet]
button: water would come out from
the SpaLet seat unit.
• Ensure that there is enough space above the remote con-
trol installation position to allow easy removal and mount of
the remote control.
2.MountingtheRemoteControl
Installation Procedure
1. Remove the holder from the remote control.
2. Install the holder to the installation
positionusinganappropriatemethodfor
the wall.
[See Note 7-2]
* Out of 4 slots, use the outer 2 slots (with A
marks). If the holder can
be installed only with a
hole pitch at 100 mm (3-
15/16"), use the inner 2
slots.
[Foraplywoodwall(>5mm(3/16")thick)]
Afx the holder rmly with the supplied wood
screws.
[Foraplywoodwall(<5mm(3/16")thick)
or a plaster board wall]

Make the pilot holes with 6 mm (1/4") diameter.
(5 mm (3/16")
diameter for a plaster
board wall)

Use a hammer to
insert the supplied
plastic anchors gently.

Afx the holder rmly
with the wood screws.
The wood screws are tight at the beginning, and then
loosened once and tightened again.
[For a concrete wall]

Make the pilot holes
with 6 mm (1/4")
diameter and ap-
prox. 33 mm (1-5/16")
depth.

Use a hammer to
insert the supplied
plastic anchors gently.

Afx the holder rmly
with the wood screws.
3. Aligntheremote
controltotheholder,
and push downward
to mount the remote
control.
Φ 6 mm (1/4")
Plastic
anchors
Holder
Wood screws
Φ 6 mm
(1/4")
33 mm
(1-5/16")
Plastic anchors
Holder
Wood screws
Holder
Remote
Control
1. InstallingtheBatteriesandConfirmingtheRemoteControlInstallationPosition
1. Openthebackcoveroftheremotecontrol,and
installtheincludedbatteries(AAx2).
[See Note 7-1]
* Use a tool such as a at-blade screwdriver to push the
hook (lock) to remove the cover.
2. Conrmtheremotecontrolinstallationposition.
Batteries
Hook (lock)
Remote control
Back cover
100mm
200mm
Holder
Wood
screws