Installation Guide

31
Cleaning Areas Covered by the Toilet Seat Lid & Unit
Removing the toilet seat lid
1. Move the pin hole on the right side
of the toilet seat lid to the outside and
remove it from the pin.
2. Hold the toilet seat up on the right
side and slide it to the left, removing it
from the pin on the left side.
If you try to pull hard to remove the toilet seat
lid, it could crack or break.
When cleaning this product, be sure to unplug the power plug from the wall outlet.
CAUTION
CAUTION
Toilet seat lid
Move to the outside.
Pin
Lift up
Slide
Toilet seat lid
Fit together.
Pin hole
Pin
Pin hole
1. Remove the power plug from the
wall outlet.
2. Close the water shutoff valve to
cut off the water supply.
Removing the seat unit
* When removing this
product, slide the unit
slowly without holding
the toilet seat or toilet
seat lid. Do not use
excessive force.
3a. Push the lock lever on the right side of the seat unit.
3b. Pull from base of seat, slide the seat forward by grasping at base,
raise it slightly and remove from toilet.
4. Carefully place the seat unit on the rim of the
toilet bowl.
5. To reinstall seat, slide it back on mounting pad.
* Do not pull.* Do not reverse
* Do not place on
the floor.
Turn clockwise.
Water
shutoff valve
Slide
forward
Lock lever
3a
3b
Slide
forward
* Do not pull.* Do not reverse
* Do not place on
the floor.
Turn clockwise.
Water
shutoff valve
Slide
forward
Lock lever
3a
3b
Slide
forward
Wipe o here.
Turn
counterclockwise.
" " mark on the
mounting plate
Protrusion on the
rear of the seat unit
1
2
When cleaning the toilet bowl, take care not to splash
the seat unit with detergent. Before installing the seat
unit, wipe the detergent off from the toilet bowl using a
cloth damped with water.
CAUTION