Installation Guide

12
WATER SUPPLY
CONNECTION SOCKET
Protective
Cover
Water
supply
socket
O-ring
Water supply
hose for
the seat
3. Installation of water supply hose to the bidet
1) Remove the protective cover
from the end of the water supply
hose, and pull out the cap from
the water supply connection
socket.
2) Connect the water supply hose
for the bidet to the water supply
connection socket.
3) Insert the attachment clip onto the
water supply hose to attach it to the
bidet and water supply connection
socket.
* The attachment clip can be attached in
any direction.
CAUTION
•Firmlyinserttheclip.
* If the clip is not rmly inserted,
it may cause water leaks.
4) Bend the clip end and firmly clip
together both the feeding hose for
the bidet and the feeding socket.
After you install the clip, twist it in
both directions to verify that it is
firmly attached, then attach the
final attachment clip over the
primary clip to secure in place.
5) Insert the clip until you feel the clip
edge click.
* If not firmly inserted, it may cause
water leaks
CAUTION
• Be careful not to damage the O-ring.
* A damaged O-ring may cause water to leak.
O-ring
Installation
Figure
Water supply
joint
Clip
Plastic
Clip
Water supply
hose