Installation Guide

33 - EN -
Heated Toilet Seat
The toilet seat is not warm.
Seat temperature is not set to an
appropriate level.
Adjust the seat temperature to the appropriate
level.
ECO mode is activated. Disable power save.
Cause
Remedy
Symptom
Troubleshooting
You can easily correct some of the problems with this product. Before requesting repairs, please check the
following items.
If you are unable to correct the problem using the troubleshooting procedures shown below, please contact your
local customer service representative.
All functions
The system will not operate
at all.
Electricity is not being supplied to
the power outlet.
Check for a power failure or tripped breaker,
etc.
The power switch is off. The LED
on the indicator panel is off.
Press the STOP button for 2 seconds to verify
the LED lights on the seat unit light up.
The power plug is not plugged into
the wall outlet.
Plug the power plug into the wall outlet.
Cause
Remedy
Symptom
Back cleansing and Front cleansing
Water does not
spray out.
The water shutoff valve is closed. Turn the water shutoff valve counterclockwise.
The inlet strainer is clogged. Clean the inlet strainer.
The seat sensor is not engaged. Sit back fully on the toilet seat.
Spray water is not warm.
Water temperature is not set to an
appropriate temperature.
Adjust the water temperature to the
appropriate level.
ECO mode is activated. Disable ECO mode.
Cause
Remedy
Symptom