Installation Guide

CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER. DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: CLEAN THE PRODUCT WITH
SOAPS, ACID, POLISH, ABRASIVES,
HARSH CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
8
7
TEST INSTALLED FITTING
9
CHECK DRAIN CONNECTIONS
1
2
3
With HANDLES (1) in OFF position, turn on WATER SUPPLIES (2)
and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES to flush water lines thoroughly.
Replace AERATOR (3).
Operate Pop-Up and fill lavatory with water. Check that DRAIN STOPPER (1)
makes a good seal and retains water in lavatory. Adjust stopper height by
repositioning Pop-Up Rod (2) and tightening Thumbscrew (3).
Release DRAIN STOPPER (1) and check all drain connections and "P" trap
for leaks. Tighten if necessary.
1
2
3
Push INDEX CAP (4) in hole of METAL CROSS (6) or PORCELAIN CROSS (7)
Secure HANDLE BASE (2) and METAL CROSS (6) or PORCELAIN CROSS (7)
with HANDLE SCREW (3).
INSTALL HANDLES (CROSS)
1
5
3
3
4
6
7
4
2
Turn VALVE into OFF position.
Push ADAPTER (1) into HANDLE BASE (3) in a way that the male square on the
ADAPTER (1) fits in the female square of the HANDLE BASE (2).
Push HANDLE BASE (2) and ADAPTER (1) onto VALVE STEM (5).
Check alignment, if not satisfactory aligned;
Push out ADAPTER (1) carefully.
Turn ADAPTER (1) either 45˚ or 90˚ so that male square on ADAPTER (1)
catches different female square in HANDLE BASE (2).
WASHER (PORCELIAN
CROSS HANDLE ONLY)
US60404E
90
1
2
10
SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Remove INSERT and HANDLE SCREW.
Slip HANDLE with ADAPTER off.
Remove SPRING CLIP (1).
Lift STOP WASHER (2), turn 90 and replace.
Replace SPRING CLIP (1).
Replace ADAPTER, HANDLE, SCREW, and INSERT.
Replace Spray and operate handles several times from
OFF to ON position. Do not force, handles turn only 90˚.
Spray may accumulate dirt causing distorted and reduced
water flow. Remove spray and rinse clean.