Installation Guide

- 2 -
M965962 (5/18)
3
4
INSTALL HANDLES
DRAIN INSTALLATION
• Apply a bead of PUTTY to underside of FLANGE on DRAIN BODY (1).
• Feed DRAIN BODY (1) down through lavatory.
• Assembly GASKET (2) WASHER (3) and LOCKNUT (4) onto DRAIN BODY (1).
Tighten LOCKNUT (4) rmly.
• Assembly TAILPIECE (5) to DRAIN BODY (1).
2
INSTALL DRAIN FROM BELOW FIXTURE
GROOVE
GROOVE
FINISHED WALL
1
1
4
9
5
6
7
4
2
TURN SPOUT 180˚
AERATOR
Figure A
1
M
A
X
W
A
L
L
M
I
N
1
-
5
/
8
"
D
E
E
P
M
A
X
W
A
L
L
M
I
N
1
-
5
/
8
"
D
E
E
P
3
8
4
5
2
3
1
LAVATORY
PUTTY
2
3
4
5
1
• Turn VALVE STEMS (1) to off position.
• Place SEAL (2) into HANDLE BASE (3).
• Thread HANDLE ESCUTCHEON (4) onto VALVE (5)
until snug against nished wall.
• Remove PLASTER GUARDS (1) from valve bodies and SPOUT NIPPLE (3).
• Inspect that SPOUT NIPPLE O-RING (2) is seated in groove of SPOUT NIPPLE (3).
• T hread SPOUT MOUNT (4) onto SPOUT NIPPLE (3). Align groove on SPOUT MOUNT (4) with face of nished wall.
See Figure A.
• Install SEAL (5) into SPOUT BASE (6). Push SPOUT (7) with SEAL (5)
onto SPOUT MOUNT (4) ush against nished wall.
• Insert SPOUT (7) upside down with the aerator facing up.
Tighten the SPOUT SET SCREW (8) with the 3 mm hex
wrench (9) supplied.
• Turn SPOUT (7) 180˚ and align until SPOUT (7) tightens
against the wall.