Installation Guide

FINISHED FLOOR

O-Rings

APPLY SEALANT

• Move HANDLE (24) onto “off” position.

• Turn on water supplies and check all connections for leaks.

Check MANIFOLD (25) connections for leaks.

• Apply sealant to underside edge of ESCUTCHEON (26). Slide

ESCUTCHEON (26) down to nished oor. Press into place.

Clean up excess sealant.

• Operate HANDLE (24) On to Off and Hot to Cold to ush water

lines thoroughly.

• Lift HAND SHOWER (22) from the HOLDER (23) and direct spray into

tub. Rotate DIVERTER KNOB (27) and check HAND SHOWER (22)

and SPRAY HOSE (20) connections for leaks.

• Rotate DIVERTER KNOB (27) back and place HAND SHOWER (22)

into HOLDER (23).

TEST INSTALLED FAUCET

• Align PIN (13) in FAUCET BASE (14) with HOLE (15) in SPOUT BASE (16). Install

SPOUT (17) into FAUCET BASE (14). Tighten the two SET SCREWS (18).

• Install SEALS (19) on both ends of the SPRAY HOSE (20). Connect the end with

the hex to the DIVERTER (21) using an adjustable wrench. Hand tighten the

connection to the HAND SHOWER (22).

Note: When not in use, the HAND SHOWER (22) should

be seated in the SHOWER HOLDER (23).

INSTALL SPOUT AND HAND SHOWER

M965639 REV. 1.2 (8/15)