Installation Guide

INSTALL TUB FILLER

Note: A minimum of four MOUNTING SCREWS (10) are required

to secure the tub ﬁller. All six are preferred.

• Install the MOUNTING SCREWS (10) through the

MOUNTING PLATE (11) and into the manifold base.

Do not fully tighten.

• Rotate the TUB FILLER (12) right or left to

align with Tub. Tighten MOUNTING SCREWS (10)

with 5 mm Hex Wrench to secure TUB FILLER (12).

5 mm HEX

WRENCH

COLD

FRONT

HOT

(VIEW “A”)

COLD

HOT

• Before nal installation, check that all sealing surfaces are

clean and that the INLET HOSE O-RINGS (7) are

not damaged.

Important: INLET HOSE O-RINGS (7) can be

damaged if caution is not used when installing.

Match inlet hose marked with a blue dot to

the hole on the manifold also marked with

blue dot. (VIEW “A”)

• Install the INLET HOSES (8) into the

MANIFOLD MOUNTING BASE (9).

BLUE DOT

(COLD)

BLUE

DOT

RED DOT

(HOT)

RED

DOT

M965639 REV. 1.2 (8/15)