Installation & Assembly

10
CHECK DRAIN CONNECTIONS
11
12
13
14
TEST INSTALLED FITTING
With HANDLES (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLES (1) to flush water
lines thoroughly.
Replace AERATOR (3).
1
HOT
COLD
2
2
5
SERVICE
Operate POP-UP KNOB (5) and fill Sink with water. Check
that DRAIN STOPPER (4) makes a good seal and retains
water in Sink. If STOPPER (4) does not seal properly, please
refer to “Troubleshooting Guide” in these instructions.
Release POP-UP KNOB (5) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
4
“P” TRAP
WASTE
OUTLET
M965465 Rev. 1.2
DO: SIMPLY RINSE THE PRODUCT
CLEAN WITH CLEAR WATER.DRY
WITH A SOFT COTTON FLANNEL
CLOTH.
DO NOT: DO NOT CLEAN THE
PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH
CLEANERS, OR A CLOTH WITH
A COARSE SURFACE.
CARE INSTRUCTIONS:
INSTALL HANDLES
Turn VALVE to OFF position.
Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. Fig. A. Tighten
STEM SCREW (3) to secure ADAPTER (1).
Align male teeth on DECK ADAPTER (5) to female teeth in LEVER
HANDLE ASSEMBLY (4). Push LEVER HANDLE ASSEMBLY (4) onto
DECK ADAPTER (5) flush against mounting surface.
Tighten SET SCREW (6) with HEX WRENCH supplied to secure
LEVER HANDLE ASSEMBLY (4). View A.
1
2
3
5
6
4
TOP
MALE TEETH
SPLINE END DOWN
Fig. A.
View. A.
FEMALE TEETH
View. A.
HEX WENCH
SUPPLIED
To change direction of handle rotation,
proceed as follows:
Turn valve to OFF position.
Loosen SET SCREW (1) and pull of
HANDLE ASSEMBLY (2).
Loosen HANDLE SCREW (3) and pull off
HANDLE ADAPTER (4).
Remove SPRING CLIP (5).
Lift STOP WASHER (6), turn 90° and replace.
Replace SPRING CLIP (5).
Refer to step four for HANDLE ASSEMBLY (2)
instructions.
If spout drips, operate handles several times
from OFF to ON position. Do not force - handles
turn only 90°.
1
2
3
4
5
6
HEX WENCH
SUPPLIED
90°
3
1