Installation Guide

- 3 -
M965820 (8/17)
6
8
9
Before the bathroom is completely finished, you may
want to remove spout, handshower, and handles.
7
TEST INSTALLED FAUCET
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
CAUTION: The flow rate of this Tub Filler exceeds 20
gallons/minute at higher water pressure.
Do not fill bathtub unattended.
1
2
3
4
5
7
8
10
9
9
11
12
6
HAND SHOWER INSTALLATION
• Turn VALVES (1) to "off" position.
• With handles in "off" position, turn on water supplies and check
all connections for leaks.
• Operate both handles and ush water lines thoroughly.
• Check SPOUT (2) mounting for leaks.
• Lift HANDSHOWER (3) from holder, direct spray into
tub, lift TRANSFER KNOB (4) to check HANDSHOWER
(3) and HOSES for leaks.
• Turn VALVES "off".
• If spout drips, operate handles several times from OFF
to ON position. Do not force - handles turn only 90˚.
4
1
1
3
2
• To remove handles, reverse steps in SE 4.
• To remove SPOUT (1), proceed as follows:
– Lift TRANSFER ROD (7) and unscrew KNOB (2).
– Remove SET SCREW (3) using 5 mm hex wrench supplied.
– Lift SPOUT (1) off SHANK (4) carefully and remove
RUBBER RING (5).
– Unscrew SHANK SLEEVE (6) and lift TRANSFER ROD (7) from
SHANK (4).
– Reverse sequence to re-install SPOUT (1). Be sure RUBBER
RING (5) is properly seated in its recess at the base of the
SPOUT (1). Make certain SET SCREW (3) is properly aligned
and tight so that SPOUT (1) is locked in place.
Hex wench, supplied
3
7
5
4
6
1
2
• Install RUBBER RING (2) on SPRAY ESCUTCHEON (1) and install SPRAY ESCUTCHEON
(1) through fth hole on tub ledge (12" max from Spout) making sure the SPRAY ESCUTCHEON
(1) opening is directed toward tub center. Install RUBBER WASHER (3), BRASS WASHER (3a) and
LOCKNUT (4) from underside of ledge. Be sure RUBBER RING (2) is properly seated in
ESCUTCHEON (1). Install RUBBER WASHER (3) and LOCKNUT (4) from underside of ledge.
• Secure SPRAY ESCUTCHEON (1) by tightening LOCKNUT (4).
• Slip SHOWER HOSE (7) with HOSE CONNECTOR through SPRAY HOLDER (5) and ESCUTCHEON
(1) from above deck. Note: SPRAY HOLDER (5) must be separate from ESCUTCHEON (1) to get
SPRAY HOSE (7) through ESCUTCHEON (1). Make sure threads on SPRAY HOLDER (5) are facing
the SPRAY ESCUTCHEON (1). Install CHECK VALVE (11) and
SEAL (8) on SPRAY HOSE (7) and connect HOSE (10) to
SPRAY HOSE (7). Install SEAL (8) on SPRAY HOSE (7) at
HAND SHOWER (9) connection and connect HAND SHOWER (9)
to SPRAY HOSE (7).
NOTE: When not in use, HAND SHOWER should be seated
in the HOLDER.