Installation Guide

- 2 -
3
M965820 (8/17)
INSTALL HANDLES
VALVE ASSEMBLY
• Push ADAPTER (1) on VALVE STEM (2), so that the hole of the
ADAPTER (1) without a spline is facing up. See figure "A".
Tighten STEM SCREW (3) to secure ADAPTER (1).
• Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting
male teeth on ADAPTER (1) to female teeth in HANDLE (4).
• Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5)
until snug against mounting surface.
9
2
4
5/16'' MIN.
MOUNTING
SURFACE
10
11
11
1
8a
MOUNTING
SURFACE
10
9
9
FOR FITTING
LESS SPRAY
10
HOT
COLD
12
13
8
5
13
12
3
7
6
1
2
4
5
3
TOP
Figure "A"
SPLINE END DOWN
THREAD ON
TO DECK
ADAPTER
INSTALL
4
• Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks.
• Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4)
into mounting holes from underside of ledge.
• Press TEE (5) onto SPOUT SHANK (6) making certain that the O-RING
(7) is properly seated on SHANK (6). Push COUPLING (8 or 8a) into
TEE (5) and attach to SPOUT SHANK (6) and tighten. For 4508.901
use a 10 mm (3/8") hex key.
• Thread of VALVE BODY (4) should extend at least 5/16 inch above
MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1).
• Place RUBBER RING (10) into ESCUTCHEON ADAPTERS (9) and
thread onto valves until snug against internal stop.
• Tighten LOCKNUT (1) to secure VALVE (4) position.
• Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4)
and tighten COUPLING NUT (13) rmly.
• Connect HOT water supply to inlet of left VALVE and COLD water
supply to inlet of right VALVE using appropriate connector.
5
SERVICE
To change direction of handle rotation, proceed as follows:
• Turn valve to OFF position. Unthread HANDLE BASE (1) from
DECK ADAPTER (2).
• Pull HANDLE ASSEMBLY off VALVE STEM (3).
• Remove SPRING CLIP (4). Lift STOP WASHER (5), turn 90˚ and
replace. Replace SPRING CLIP (4).
• Find correct position of HANDLE ASSEMBLY by adjusting male
teeth on VALVE STEM (3) to female teeth in HANDLE.
• Thread HANDLE ASSEMBLY onto DECK ADAPTER (2) until snug
against mounting surface.
2
90˚
4
3
5
HANDLE
ASSEMBLY
REMOVE
HANDLE