Installation & Assembly

M965779 (3/17)
11
12
• With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
• Remove AERATOR (3).
• Operate HANDLE (1) to ush water lines thoroughly.
• Replace AERATOR (3).
CHECK DRAIN CONNECTIONS
• Operate POP-UP KNOB (4) and ll lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in Sink. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
• Release POP-UP KNOB (4) down and check all drain
connections and “P” trap for leaks. Tighten
if necessary.
• To remove or replace cartridge:
– Turn valve to OFF position.
– Pull out PLUG BUTTON (1) and remove HANDLE SCREW (2).
– Pull off HANDLE ASSEMBLY (3).
– Unthread CARTRIDGE NUT (5) using a 7/8" socket (deep socket)
and remove.
– Pull out CARTRIDGE (6).
– Inspect CARTRIDGE (6) and O-RINGS (7) for debris and
clean if necessary.
– Clean MANIFOLD (8) and rinse clean.
– Reinstall CARTRIDGE (6) and O-RINGS (7) onto
MANIFOLD (8).
– Reinstall CARTRIDGE NUT (5) and CAP (4) (orientation of the
cap is very important).
– When reinstalling the HANDLE (3) push the lower gear back
(as shown in the gure) then install HANDLE (3) in pushed down
position (make sure the seal alligns with the body).
– Push SEAL (4) down, ensuring that it is completely pushed into
the spout body.
– Reinstall HANDLE SCREW (2) and PLUG BUTTON (1).
SERVICE
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
TEST INSTALLED FITTING
10
1
4
3
OFF
ON
5
“P” TRAP
WASTE
OUTLET
2
2
HOT
COLD
CAUTION
Turn off hot and cold water
supplies before beginning.
8
5
6
REMOVE
INSTALL
7
10
4
1
2
2.5mm HEX KEY
3
LOWER GEAR