Installation & Assembly

- 3 -

• Thread CABLE CONNECTOR (1) clockwise

onto DRAIN BODY CONNECTION (2) and

hand tighten. Fig. A.

Your new POP-UP DRAIN installation is

now complete. Fig. B.

Note: Tailpipe on pop-up drain is 1-1/4"

O.D. Fig. B.

• Operate LIFT KNOB (1) to verify that STOPPER (2) opens and

closes.

Note: If STOPPER (2) does not open and close properly then

refer to the “troubleshooting section” of these instructions.

CHECK OPERATION OF POP-UP

MAKE WATER SUPPLY AND WASTE CONNECTIONS

ATTACH CABLE CONNECTOR

M965779 (3/17)

Fig. A.

Fig. B.

1-1/4" O.D.

APPROX. 20"

COLD

HOT

3/8" COMPRESSION

BLUE

BAND

RED

BAND

• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies.

Connection on tting supplies are 3/8" compression.

Connect right SUPPLY (2) to Hot (Marked with a Red Band)

and left supply to COLD (1) wall supply.

• Faucet supplies are 20" long from faucet base.

Note: If additional supply length is required, installer must

purchase additional parts separately.

Important: If SUPPLY HOSES (1, 2) are to long, loop as

illustrated to avoid kinking.

• Connect 1-1/4" O.D. tail piece on POP-UP DRAIN to

waste outlet.