Installation & Assembly

- 2 -
2
M965779 (3/17)
3
REMOVE FLANGE
• Remove CLEAR PLASTIC COVER (1).
• Remove CARDBOARD SPACER (2) from under
DRAIN POP-UP (3).
• Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
POP-UP DRAIN
• Thread FLANGE (1) counter-clockwise and
remove FLANGE (1) and FOAM GASKET (2)
from drain body. Fig. A.
• Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B.
4
INSTALL DRAIN FROM
BELOW FIXTURE
• From under side of SINK
install DRAIN BODY (1) up
through drain outlet.
Note: No plumber’s putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face towards
the rear of the SINK.
• Install FOAM GASKET (3) on
to bottom of ange and
assemble FLANGE (4) onto
drain body from above sink
and tighten FLANGE (4) rmly.
2
3
1
Fig. A. Fig. B.
DRAIN
BODY
4
2
3
4
Fig. B.
1
Fig. A.
6
FLANGE GASKET AND POP-UP KNOB
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
• P O P -UP KNOB (1) must be pressed completely
down Fig.B while pop up is in the full up position.
2
DRAIN
OUTLET
1
3
4
REAR OF SINK
5
TIGHTEN LOCKNUT
• Tighten LOCKNUT (1) rmly with Adjustable
Wrench or Channel Locks.
1
WHITE FOAM
GASKET
NOT VISIBLE
DRAIN
FLANGE
Fig. A. Fig. B.
DOWN
1