Installation Guide

4
MAKE WATER SUPPLIES & WASTE CONNECTIONS
• Connect FLEXIBLE SUPPLIES (1, 2) directly to wall
supplies.
Connection on fitting supplies are 3/8" (10 mm)
compression.
Connect left SUPPLY (1) to Hot and right supply to
COLD (2) wall supply.
Note: Faucet supplies are 24" (610 mm) long from
faucet base.
Note: If additional supply length is required, installer
must purchase additional parts separately.
Important: If SUPPLY HOSES (1, 2) are too long, loop
as illustrated to avoid kinking.
• Connect 1-1/4" O.D. (32 mm) tailpiece on PUSH
DRAIN to waste outlet.
5
MAKE FAUCET HOSE CONNECTIONS
• Push T-CONNECTOR (3) on to BRACKET (1)
connection is secured with a audible click.
• Push SIDE VALVE HOSE (2) on to T-CONNECTOR (3)
and slide the hose locking collar towards the
T-CONNECTOR (3) to secure the connection.
Repeat this for both side valve hoses.
D
24"
(610 mm)
COLD
HOT
3/8"
COMPRESSION
1
2
“P” TRAP
OUTLET
WASTE
1
2
3