Installation Guide

INSTALLATION INSTRUCTIONS
1
3
INSTALL SPOUT
INSTALL DRAINS
• Make certain the SEAL (6) is properly seated in recess of
faucet body.
• Insert SPOUT SHANK (1) through the deck.
• Assemble RUBBER WASHER (2), BRASS WASHER (3), and
threaded LOCKNUT (4) onto SHANK (1) from underside of sink
or mounting surface. Hand tighten LOCKNUT (4).
• Use a screwdriver to tighten SCREWS (5) on LOCKNUT (4).
Work your way around LOCKNUT (4), tightening the screws
slightly each time until all are snug to ensure even pressure.
Note: Deck Hole diameter must be 1-1/4" minimum.
Turn off hot and cold water supplies
before beginning.
1
2
3
4
5
2
INSTALL VALVE BODIES
• Insert HANDLE SHANK (1) through the deck.
• Thread MOUNTING NUT (2) on to SHANK (1).
• Insert DRAIN SHANK (1) through the sink basin.
• Slide RUBBER GASKET (2) and WASHER (3) on to
DRAIN SHANK (1) from below the sink basin.
• Thread MOUNTING NUT (4) on to DRAIN SHANK (1)
from below the sink basin and hand tighten.
Note: To operate the drain, push down on the top to
toggle it open or closed.
1
2
1
2
3
6