Installation Guide

SPOUT ASSEMBLY INSTALLATION;
Fig. 1
TOOLS REQUIRED; Fig. 2
Fig. 2
1 2.5 mm Hex Wrench
(Included)
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Tape Measure
1
2
3
4
5
10'
Fig. 1
457mm
(18)
3/8" COMPRESSION
CONNECTORS
CLEARANCE
25mm (min) - 127mm (max)
(1" min - 5" max)
165mm
(6-1/2)
28mm (1-1/8)
66mm
( 2-5/8)
38mm
(1-1/2 )
140mm
(5-1/2)
191mm
(7-1/2)
191mm
(7-1/2)
MOUNTING
SURFACE
FINISHED WALL
OR BACKSPLASH
Roughing-in Dimensions
2
Turn off hot and cold water supplies before beginning
1
Fig. 1
10
6
PUTTY
(If required)
MOUNTING
SURFACE
(OPTIONAL)
TIGHTEN
SPIN NUTS
1. Make sure O-RING (1) is installed in spout base. If installing
ESCUTCHEON (2) (optional): Apply a bead of putty to
bottom edge of ESCUTCHEON PUTTY PLATE (2).
IMPORTANT: Do not use putty when installing faucet
without escutcheon.
2. Insert supply HOSES (3), SHANK (4) and SENSOR CABLE
(5) (if equipped) through hole in ESCUTCHEON with PUTTY
PLATE (2) and mounting surface. (Make sure PIN (6) is in back).
3. Assemble RUBBER WASHER (7), BRASS WASHER (8)
and THREADED LOCKNUT (9) onto SHANK (4) from
underside of sink or mounting surface. Hand tighten
LOCKNUT (9).
4. Use a screwdriver to tighten SCREWS (10) on LOCKNUT
(9). Work your way around LOCKNUT (9), tightening the
screws slightly each time until all are snug to ensure
even pressure.
CAUTION
Note: All plumbing and electrical wiring must be installed
in accordance with applicable codes, regulations and
standards.
RECOMENDED CONTROL BOX OR
EQUIVALENT BY OTHERS
HARD-WIRED AND MULTI AC 10' MAX. CABLE LENGTH
4" (102mm) SQ. X 3-1/2" (89mm) DEEP CONTROL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).
INSTALLATION
2
1
4
3
7
8
9
5
IMPORTANT: Do not
use putty when installing
faucet without escutcheon.
IMPORTANT: Do not
use sealent on threads
CAUTION: Use only American Standard supplied transformers and
cable sets. Using non-AS supplied cables, or cutting, splicing or
modifying any components will void the warranty.
M965654 Rev. 2.0 (9/16)