Specifications

M965654 Rev. 1.2 (2/15)

1. Remove the FAUCET COVER (1) by unthreading the

LEVER SCREW (2) and pulling off the LEVER

HANDLE (3). Unthread the FAUCET COVER

SCREW (4) at the back of the FAUCET. Pull FAUCET

COVER (1) up and off. See Fig. 2 in this section.

2. Disconnect both ELECTRICAL CONNECTIONS. Fig. 5.

3. Untighten SENSOR SCREW (1) with a 2.5mm HEX

WRENCH. Remove SENSOR ASSEMBLY (2) from

FAUCET BODY (3). Remove O-RING (5). Remove

SENSOR (2a) from CARRIER (4) and replace with

new SENSOR (2a). Replace O-RING (5). Install

SENSOR ASSEMBLY (2) into FAUCET BODY (3).

Tighten SENSOR SCREW (1). Fig. 6, 7.

4. Replace FAUCET COVER (1) and LEVER HANDLE (3).

Install LEVER HANDLE SCREW (2), FAUCET COVER

SCREW (4) and tighten. See Fig. 2 in this section.

REPLACE SENSOR;

Fig. 5, 6 & 7.

Fig. 5

DISCONNECT

WIRE CONNECTIONS

Fig. 6

2.5mm HEX

WRENCH

Fig. 7