Specifications

SPOUT ASSEMBLY INSTALALTION;
Fig. 1
TOOLS REQUIRED; Fig. 2
Fig. 2
1 Hex Wrench (Included)
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Tape Measure
1
2
3
4
5
10'
Fig. 1
457mm
(18)
3/8" COMPRESSION
CONNECTORS
MIN. 1"
CLEARANCE
165mm
(6-1/2)
32mm (1-1/4)
66mm
( 2-5/8)
38mm
(1-1/2 )
140mm
(5-1/2)
191mm
(7-1/2)
191mm
(7-1/2)
MOUNTING
SURFACE
FINISHED WALL
OR BACKSPLASH
Roughing-in Dimensions
2
M965654 Rev. 1.2 (2/15)
Turn off hot and cold water supplies before beginning
1
Fig. 1
10
6
PUTTY
(If required)
MOUNTING
SURFACE
(OPTIONAL)
TIGHTEN
SPIN NUTS
1. Make sure O-RING (1) is installed in spout base. If installing
ESCUTCHEON (2) (optional): Apply a bead of putty to
bottom edge of ESCUTCHEON PUTTY PLATE (2).
IMPORTANT: Do not use putty when installing faucet
without escutcheon.
2. Insert supply HOSES (3), SHANK (4) and SENSOR CABLE
(5) (if equipped) through hole in ESCUTCHEON with PUTTY
PLATE (2) and mounting surface. (Make sure PIN (6) is in back).
3. Assemble RUBBER WASHER (7), BRASS WASHER (8)
and THREADED LOCKNUT (9) onto SHANK (4) from
underside of sink or mounting surface. Hand tighten
LOCKNUT (9).
4. Use a screwdriver to tighten SCREWS (10) on LOCKNUT
(9). Work your way around LOCKNUT (9), tightening the
screws slightly each time until all are snug to ensure
even pressure.
CAUTION
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal resistant
solid brass construction single post mounting. Operates on
DC (battery/power pack) or AC permanent power
(plug-in/hardwire). In-line strainer for solenoid is integral.
Single inlet 3/8 compression, built-in check valves, and flexible
stainless steel 16-1/4" reach inlet hose for spout connection.
Note: All plumbing and electrical wiring must be installed
in accordance with applicable codes, regulations and
standards.
RECOMENDED ELECTRICAL BOX OR
EQUIVALENT BY OTHERS
HARD-WIRED AND MULTI AC 10’ MAX. CABLE LENGTH
4" (102mm) SQ. X 3-1/2" (89mm) DEEP ELECTRICAL BOX
Hubbel-RACO #256 OR EQUAL (BY OTHERS).
INSTALLATION
2
1
4
3
7
8
9
5
I
MPORTANT: Do not
use putty when installing
faucet without escutcheon.
IMPORTANT: Do not
use sealent on threads
CAUTION: Use only American Standard supplied transformers and
cable sets. Using non-AS supplied cables, or cutting, splicing or
modifying any components will void the warranty.