Installation Guide

- 3 -

• Thread CABLE CONNECTOR (1) clockwise

onto DRAIN BODY CONNECTION (2) and

hand tighten. Fig. A.

Your new POP-UP DRAIN installation is

now complete. Fig. B.

Note: Tailpeice on pop-up drain is 1-1/4" O.D.

Fig. B.

CHECK OPERATION OF POP-UP

ATTACH CABLE CONNECTOR

Fig. A.

Fig. B.

1-1/4” O.D.

• Operate LIFT KNOB (1) to verify that STOPPER (2) opens

and closes.

Note: If STOPPER (2) does not open and close

properly then refer to the “troubleshooting section” of

these instructions.

M965805 (3/17)

• Remove AERATOR. With handles in OFF position, turn on water supplies and check all connections for leaks.

• Operate both handles to ush water lines thoroughly. Operate LIFT ROD and check DRAIN for leaks. Replace AERATOR.

TEST INSTALLED FAUCET