Installation Guide

- 2 -
2
3
M965804 (4/17)
• Remove CLEAR PLASTIC COVER (1).
• Remove CARDBOARD SPACER (2) from under
DRAIN POP-UP (3).
• Tighten TAILPIECE (4) on DRAIN BODY before
installing DRAIN BODY. Fig. B.
POP-UP DRAIN
2
3
1
Fig. A. Fig. B.
DRAIN
BODY
4
• Thread FLANGE (1) counter-clockwise and
remove FLANGE (1) and FOAM GASKET (2)
from drain body. Fig. A.
• Thread LOCKNUT (3) clock-wise to bottom of
drain body. Push GASKET (4) down against
LOCKNUT (3). Fig. B
REMOVE FLANGE
2
3
1
4
Fig. A. Fig. B.
4
• From under side of SINK install
DRAIN BODY (1) up through
drain outlet.
• Note: No plumber’s putty
or caulk is required.
The CABLE ATTACHMENT
POINT (2) must face towards
the rear of the SINK.
• Install FOAM GASKET (3) and
FLANGE (4) onto drain body
from above SINK and tighten
FLANGE (4) rmly.
INSTALL DRAIN FROM
BELOW FIXTURE
REAR
OF
SINK
2
DRAIN
OUTLET
1
3
4
6
5
1
• Tighten LOCKNUT (1) rmly with
Adjustable Wrench or Channel Locks.
TIGHTEN LOCKNUT
• Check DRAIN FLANGE in SINK to ensure that
WHITE FOAM GASKET (3) is fully compressed
and not visible. Fig. A.
• POP-UP KNOB (1) must be fully down. Fig. B.
FLANGE GASKET AND POP-UP KNOB
1
DOWN
WHITE FOAM
GASKET
NOT VISIBLE
DRAIN
FLANGE
Fig. A. Fig. B.