Installation Guide

10
M965651 Rev. 1.5 (10/16)
Fig.6
F
GENERAL CLEANING; Fig. 5
1. Only use a damp, soft cloth to clean the spout and
the sensor.
2. For tougher dirt, use a soft cloth with diluted dish
washing detergent. Wipe the area using a wet cloth.
CAUTION
Do not scratch the sensor when cleaning. Avoid using
any abrasives or harsh detergents or chemicals.
FAQ’S
Q:HowwillIknowifthebatteryneedstobereplaced?
A:Valvewillnotopenandsensorwillcontinuouslyblink2timesinterruptedbyapause,forupto7days.
Q:Whyhastheowrateofthefaucetreducedsignicantly?
A:Thelterassembly,owregulatororareator/spraymaybeclogged.Checkandclean.RefertoStart-up/
Mainenance,sectionsC,DandE.
Q:Whydoesn’twaterowoutoffaucetwhenI’mwithinthesensordetectionzone?
A:Batterymayneedreplacement.Ifsensorcontinuouslyblinks2timesinterruptedbypause,replacebattery
orcall(844)CRT-TEAM/(844)278-8326.Z
Q:Whatisthenormaloperatingpressurerange?
A:Faucetwilloperatewithsupplypressuresrangingfrom20-80psi.