Specifications

RECOMMENDED TOOLS
1 Channel Locks
2 Adjustable Wrench
3 Plumbers' Putty or Caulking
4 Phillips Screwdriver
5 Flat Blade Screwdriver
6 Electric Drill & 1/4" Drill Bit
7 Tape Measure
1
2
3
4
5
6
7
10'
114mm
(4-1/2)
500mm
(20")
413mm
(16-1/4)
FINISHED
WALL
32mm
(1-1/4) DIA.
125mm
(4-7/8)
60mm
(2-3/8) MAX.
MOUNTING
SURFACE
(243mm)
9-9/16"
(127mm)
5"
(133mm)
5-1/4"
Roughing-in Dimensions
GENERAL DESCRIPTION:
Electronic faucet with proximity operation. Vandal
resistant solid brass construction single post
mounting. Operates on AC permanent power.
In-line strainer for solenoid is integral. Single inlet
3/8 compression, built-in checks, and flexible
stainless steel 16-1/4" reach inlet hose for spout
connection.
Note: All plumbing and electrical wiring must
be installed in accordance with applicable
codes, regulations and standards.
Fig. 1a
Fig. 1
2
1
2
3
4
5
6
3
3/8" COMP.
81mm
(3-3/16)
(53mm)
2-1/8" DIA.
ELECTRICAL BOX OR
EQUIVALENT BY OTHERS
M 9 6 5 27 1 R EV. 1.3
1
INSTALL SPOUT ASSEMBLY;
Fig. 1, 1a
INSTALLATION
CAUTION
Turn off hot and cold water
supplies before beginning
1
Note: Installation shown less optional deck plate. Fig.1.
1. Connect the two 27" EXTENSION CABLES (1) to
the Faucet Sensor Cables. Fig. 1.
2. Insert 27" EXTENSION CABLES (1) , FLEX HOSE
(2) and SPOUT SHANK (3) through center hole of
mounting surface. Fig. 1a.
3. Assemble "C" WASHER (4), STAR WASHER (5)
and LOCKNUT (6) onto threads of SPOUT SHANK (3)
from underside of mounting surface. Fig. 1a.
4. Align FAUCET and tighten LOCKNUT (6) to secure
FAUCET to mounting surface. Fig. 1a.
FAUCET
SENSOR
CABLES
INSTALLATION SHOWN
LESS DECK PLATE
CAUTION: Use only American Standard
supplied cable sets. Using non-AS supplied
cables, or cutting, splicing or modifying any
components will void the warranty.