Installation

4
Fig. 1a
Fig. 1b
1. Remove ENCLOSURE COVER (1). Fig. 1.
2. Feed the WIRE CONNECTORS (2) through the top
of ENCLOSURE (5). Fig. 1a.
3. Remove GROMMET (4) from ENCLOSUR (5). Fig.1.
4. Feed the gray SENSOR WIRE (7) through
GROMMET (4), 4" from CONNECTOR. Fig. 1b & 1d
Insert gray SENSOR WIRE (7) into SPLIT PLUG (9).
Push SPLIT PLUG (9) into GROMMET (4) to seal.
Fig. 1d.
5. Insert GROMMET (4) back into ENCLOSURE (5).
Fig. 1c.
6. Install BATTERY (11) onto DC circuit board. Fig.1e.
Note: For BATTERY PACK installation see "Install
Battery" page 7.
7. Install CIRCUIT BOARD (3) into ENCLOSURE (5)
with SENSOR WIRE (7) under BOARD. Fig. 1c.
8. Insert SENSOR WIRE CONNECTOR (8) into
CIRCUIT BOARD RECEPTOR (10). Fig. 1e.
9. Connect wires from SENSOR to SOLENOID VALVE
(6) (Red to +, Black to -). Fig. 1c.
10. Replace ENCLOSURE COVER (1). Tighten cover
screws firmly.
DC VERSION (BATTERY); Fig. 1
1
4
BLACK
8
RED
6
5
7
ELECTRICAL INSTALLATION
Fig. 1c
Fig. 1d
7
9
4
8
11
10
Fig. 1e
3
1
5
4
Fig. 1
4
7
4"
5
2
M968809 Rev.1.4